What to do when rounding the mark
Mark roundings decide places because the whole fleet compresses into a small space. A clean rounding with a plan for the next leg often gains more than a whole leg of boatspeed.
Before you get there
- Decide the next leg early. Which side of the run or beat is favoured, and will you go straight, gybe or tack after rounding?
- Know the rules that apply. Check the sailing instructions for mark-room zone size, then work out who is entitled to room before you reach it.
- Make the calls. One person calls the approach, one calls the set or drop. Keep the boat quiet otherwise.
Windward mark
- Approach on the layline with speed. Pinching up to make the mark loses more than a short extra hitch.
- Prepare before the bear-away. Pole or sprit ready, halyard and sheets clear, the outhaul and backstay eased as your class allows.
- Bear away smoothly. Ease the main and jib as you turn so the boat does not round up, then set when the bow is clear of the mark.
- Look for clean air. Boats behind you will try to cover your wind on the run. Decide whether to defend or gybe away.
Leeward mark
- Drop early enough. A late drop is the most common cause of a bad rounding. Practise the drop you will use today.
- Wide in, tight out. Approach wide so you can turn close to the mark and exit on a tight upwind course, not sliding to leeward.
- Trim for upwind as you turn. Sheets in, controls on, crew to the rail, all before the boat is close-hauled.
- Choose your gate. At a leeward gate, pick the mark that leads to the favoured side, unless traffic at that mark costs more than the gain.
After the rounding
Look back at where the fleet is going and what the breeze is doing. The first two minutes of the new leg set up the next mark.
Related guides
Smooth sets and drops start with running rigging that runs free. Shop blocks or rope and rigging.