One-design race shop · Dinghy
Hansa 303 Race Shop
Everything you need to prepare, compete, and win.
Fit verified for Hansa 303
All Hansa 303 equipment
18 parts
Fit verified for Hansa 303
Nautalytics
Nautalytics Mast Mount Compass (Digital Compass)
Part # NTL-MASTMOUNT
$500.00
Fit verified for Hansa 303
Nautalytics
Nautalytics Bulkhead Mount Compass (Digital Compass)
Part # NTL-BULKHEADMOUNT
$400.00
Fit verified for Hansa 303
Sea-Dog
Sea-Dog Poly Pro Anchor Line w/Snap - 1/4" x 100' - Yellow
Part # SDG-304206100YW-1
$15.73
$16.30Fit verified for Hansa 303
Lalizas
Lalizas Cabo Floating Rope Diam. 15/64'' (6Mm), L 98,43Ft (30M), Orange
Part # LAL-94801
$14.28
Fit verified for Hansa 303
Rooster
Rooster Tell Tales - Teflon Coated (3 Green & 3 Red)
Part # ROO127491
$8.96
$9.95Fit verified for Hansa 303
Sea-Dog
Sea-Dog Poly Pro Anchor Line w/Snap - 1/4" x 50' - Yellow
Part # SDG-304206050YW-1
$9.50
$9.85Fit verified for Hansa 303
Sea-Dog
Sea-Dog Poly Pro Anchor Line w/Snap - 3/8" x 75' - Yellow
Part # SDG-304210075YW-1
$27.83
$28.85Fit verified for Hansa 303
Lalizas
Lalizas Cabo Floating Rope Diam. 20/64'' (8Mm), L 98,43Ft (30M), Orange
Part # LAL-70260
$12.46
Fit verified for Hansa 303
Ronstan
Ronstan Tell Tales - Tell Tails Kit (3 Pairs)
Part # RONRF4025
$9.91
$11.66Fit verified for Hansa 303
Ronstan
Ronstan Tell Tales - Leech Tails Kit (3 Pairs)
Part # RONRF4026
$9.91
$11.66
No Hansa 303 parts match these filters.
Can’t find a part for your Hansa 303? Request a Hansa 303 part
Go fast
Hansa 303 tuning guide
The Hansa 303 has unstayed, furling main and jib masts, so there's no rig tension to set: 'tuning' is outhaul, sheeting, jib lead hole, traveller bridle height, heel and reefing. World Sailing treats it as a non-technical boat, and the one published guide is a sailor's personal notes hosted by the builder.
Chris Symonds (via Hansa Sailing) — Hansa 303 Tuning Guide October 2022
- Written for
- Standard furling main and jib
- Tension gauge
- Not applicable (unstayed masts)
- How it’s measured
- Personal settings of a 60 kg sailor with limited strength; may not suit everyone.
- Source
- Chris Symonds (via Hansa Sailing), October 2022
Base setup
- Jib luff (foremast) tension
- Kept to a minimum in all conditions
- Jib lead
- Rear hole in the jib track upwind in all conditions
- Rear bridle (traveller)
- High in all conditions, so the boom can come to centreline; set it horizontal and extended to the rear seat bar as a length guide
- Sheet marks
- Tape on the mainsheet and jib sheets as trim references
Trim by condition
- Outhaul
- Tight for strong winds; eased up to a maximum of 100 mm off the boom in mid-range winds with waves; not adjusted downwind.
- Sheeting
- Over-sheeting stops the boat, especially in waves. Out of tacks (short waves, light air) trim gradually and only pull to the full setting at full speed; ease or trim through gusts. Downwind in medium–strong wind don't let the main out so far that the top third spills.
- Heel
- Flat is fast in light winds and flat water; no more than 15°. Upwind in waves some heel keeps the boat dry.
- Reefing
- Full main carried to about 20 kn at this sailor's weight.
- Seating
- Weight forward in light winds (not past the joystick); back corner upwind in heavy air.
- Steering
- Joystick should move freely without slop; Spectra steering lines for feel; steer high in strong winds keeping heel constant.
- Downwind
- Always goose-wing the jib (hold it out by hand in light–medium air); sit back and keep the boat flat in strong winds.
- Equipment
- Jib window for big fleets; tape halyard/clew and bridle shackles; check centreboard carpet so the foil doesn't wobble; make sure the furled sails fully open before launching.
- A personal guide by an experienced 303 sailor, hosted on the builder's site; not a sailmaker's guide.
Settings are summarised from each sailmaker’s published guide (checked 2026-11-02). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.
Technical
Hansa 303 resource centre
How we verify parts
- Fit verified
- Each part listed here was matched to the Hansa 303 by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
- Class rules
- Fitting a part is not the same as it being legal for racing. Read the current Hansa 303 class rules before changing equipment, and ask your class measurer if a part is not original equipment.
- Class rules303 Class Rules 2022 (WS-approved change effective 18 May 2022)
- Class associationhansaclass.org
- Builder specificationsHansa 303 on hansasailing.com
- Racing guideThe right gear for the right application
- Racing guideWhat to do when rounding the mark
- Racing guideHow to conquer the layline
- Rigging helpRequest a Hansa 303 part