One-design race shop · Keelboat

J/92 Race Shop

Everything you need to prepare, compete, and win.

Shopping for

J/92

  • 60 verified parts
  • 12 brands

Fit verified for J/92

All J/92 equipment

60 parts

Can’t find a part for your J/92? Request a J/92 part

Go fast

J/92 tuning guide

The only published set-up for the original J/92 is J/Boats' own owner-guide starting point, based on the Johnstones' boat: standard headstay, rake measured at the cabin top, mast wedged forward and shrouds set up by sight at 12–14 kn. It gives no wind-range chart; ask your sailmaker for one, and don't use J/92s numbers.

J/Boats — J/92 Owner Manual: Tuning the J/92 Rig Owner manual, undated (the jowners.org scan was made in October 2007)

Written for
Starting point from Jeff and Al Johnstone's J/92 #3; standard double-spreader Hall Spars rig
Tension gauge
Loos gauge mentioned only as a check, in pounds (model not stated)
How it’s measured
Rake from the back of the mast to a weighted main halyard, measured on the cabin top.
Source
J/Boats, Owner manual, undated (the jowners.org scan was made in October 2007)

Base setup

Headstay
Standard length with about 2.5" of thread showing under the Harken drum, no toggles
Backstay
Set up with a toggle under the hydraulic cylinder so the handle is forward and the release aft
Mast step
Bolts in the middle of the slots
Rake
24" from the back of the mast to a weighted main halyard on the cabin top
Mast wedges
None to start; after tightening uppers and intermediates the mast is winched back with a jib sheet round the front to fit the forward wedge, then the rest
Heavy air reference
Up to 2,200 lbs on uppers and lowers at Block Island for heavy conditions

Trim by condition

Centring
With shrouds hand-taut, centre the mast with the main halyard to the rail outboard of the chainplates, then apply maximum backstay to bend the mast.
Shroud sequence
Tighten uppers and intermediates equally with a wrench until fairly tight; then lowers hand-tight, making sure the mast is not inverted (the asymmetric makes it worse).
Sailing check
In 12–14 kn with max backstay, take up the leeward upper and intermediate two full turns each; ease the backstay to intermediate and take the leeward lower up hand-taut; tack and repeat, then fine-tune on the leeward side only.
  • Builder's starting point for the original J/92 only (not the J/92s). The PDF is a scan, so the text was read from the page image.

Settings are summarised from each sailmaker’s published guide (checked 2026-11-02). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.

Technical

J/92 resource centre

How we verify parts

Fit verified
Each part listed here was matched to the J/92 by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
Class rules
We have no current one-design class rules on file for the J/92. Racing legality depends on your class or handicap rules; check them before changing equipment.