One-design race shop · Dinghy

Europe Race Shop

Everything you need to prepare, compete, and win.

Shopping for

Europe

  • 20 verified parts
  • 6 brands
  • Fit checked Nov 2026

Fit verified for Europe

All Europe equipment

20 parts

Can’t find a part for your Europe? Request a Europe part

Go fast

Europe tuning guide

The Europe has an unstayed mast, so tuning means mast rake (moved a centimetre or two either side of a base setting), traveller, outhaul, inhaul, cunningham and centreboard height by wind. North Sails is the only sailmaker we found with a published guide; its rake base is printed as "5440cm" with no measuring points, so treat it as a reference to set your own base against.

North Sails — Europe Tuning Guide Undated (current North Sails page)

Written for
North Sails Europe Class mainsail
Tension gauge
Not applicable (unstayed rig); rake changes given in cm from a base position
How it’s measured
Mast rake by tape. The guide gives a base of "5440cm" but does not say where it is measured from or to. All other settings are distances: outhaul from the black band, inhaul from the aft edge of the mast, traveller as where the boom end sits on the deck/tank.
Source
North Sails, Undated (current North Sails page)

Base setup

Mast rake base
"5440cm" as printed (start point; rake is then moved back or forward by 1–3 cm with wind)
Reference
Use trim scales on the boat so settings can be repeated

Upwind settings by wind (rake relative to base)

True wind (kn)Mast rakeTraveller (boom end)Outhaul (from black band)InhaulCunninghamCentreboardMainsheet / leech
0–5About 2 cm back from baseMid tank6 cm forward of the bandLoose, 3 cm back from aft edge of mastLooseNot statedTop telltale stalls 20% of the time; keep leech loose
5–102 cm back at about 5 kn; base from 6 kn; 1–2 cm forward from about 9 kn once the boom reaches the deckMid tank to transom cornerAbout 6 cm in flat water, about 10 cm in chopLoose (3 cm from mast) in flat water; tightened in chopLooseNot statedTop telltale stalls 30%; boom reaches the deck from about 9 kn
10–15Base to 1–2 cm forwardFrom 3 cm off the inside corner to the transom corner; play it in puffs4–9 cm (tighter than 5–10 kn)TightenedStart at about 14 kn, just smoothing luff wrinklesLift about 10 cm from about 14 knBoom on the deck at all times
15–20Base to 1–2 cm forward at about 15 kn; base at about 20 knTransom corner to a few cm outside itAbout 4 cm to maximumMaximumTight enough to remove all luff wrinklesLift about 20 cmTight, boom on the deck
20–25Base to 1–3 cm backBoom end outside the transom corner at all timesMaximumMaximumTight to maximumAlmost up to deck levelTight, played in puffs

Trim by condition

Upwind, general
Hike hard even though the Europe is less physical than a Laser or Finn; sitting passively on the side is slow.
Leech control
Once the boom is on the deck the sheet no longer adds leech tension, so rake the mast forward 1–2 cm to get it.
Before the windward mark
Set controls before rounding: release cunningham and inhaul, ease outhaul to suit the wind (keeping the boat manageable round the mark).
Vang downwind
In stronger winds preset the vang so the top batten is 2–3° open relative to the boom.
Mainsheet downwind
Play the sheet 1:1 from the boom until the load is too much, then switch to 2:1; in more wind take it straight from the ratchet block.
Waves
Steering comes before pumping and rocking; don't stay on one wave too long, use the speed to catch the next one and link waves continuously.
  • The rake base is printed exactly as "5440cm" (re-checked 2026-11-03). 54.4 m is impossible for a Europe, so the unit is wrong; 5440 mm is the likeliest reading, but the guide gives no measuring points, so check against your own boat.
  • No date, author or sail model name is shown on the page.
  • The guide only mentions the centreboard from about 14 kn upwards (lift about 10 cm, then 20 cm, then almost to deck level).

Settings are summarised from each sailmaker’s published guide (checked 2026-11-03). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.

Technical

Europe resource centre

How we verify parts

Fit verified
Each part listed here was matched to the Europe by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
Class rules
Fitting a part is not the same as it being legal for racing. Read the current Europe class rules before changing equipment, and ask your class measurer if a part is not original equipment.