One-design race shop · Dinghy
RS Feva Race Shop
Everything you need to prepare, compete, and win.
Fit verified for RS Feva
All RS Feva equipment
14 parts
Fit verified for RS Feva
Selden
Selden Pop-rivet, ø4,8 X 12,7 mm, Monel, Countersunk
Part # sel-167-022-05
$36.00
Fit verified for RS Feva
Lalizas
Lalizas Cabo Floating Rope Diam. 15/64'' (6Mm), L 98,43Ft (30M), Orange
Part # LAL-94801
$14.28
Fit verified for RS Feva
Velocitek
Velocitek Mast Bracket for Prostart or SpeedPuck
Part # VELPROMMB
$69.00
Fit verified for RS Feva
Lalizas
Lalizas Cabo Floating Rope Diam. 20/64'' (8Mm), L 98,43Ft (30M), Orange
Part # LAL-70260
$12.46
Fit verified for RS Feva
Ronstan
Ronstan ClearStart Race Timer - Unisex (Black)
Part # RSGRF4050
$118.96
$139.95
No RS Feva parts match these filters.
Can’t find a part for your RS Feva? Request a RS Feva part
Go fast
RS Feva tuning guide
The RS Feva is built to need little tuning: shroud-adjuster hole, jib-halyard rig tension and where the mast sits in the deck partner are the main settings. Only basic published numbers exist (a builder starting hole and one gauge reading from the US distributor), and the Loos gauge model isn't named.
Zim Sailing — RS Feva Tips and Tricks 15 June 2022
- Written for
- RS Feva class sails
- Tension gauge
- Loos gauge (model not stated)
- How it’s measured
- Rig mode is judged by where the mast sits in the deck partner; the mast step and partner are the only parts consistent from boat to boat.
- Source
- Zim Sailing, 15 June 2022
Base setup
- Heavy-air rig tension
- 10 on the Loos gauge
Rig modes by wind
| Wind | Mast in partner | Mast shape | Notes |
|---|---|---|---|
| Light | Touching the front of the partner | Inverted | Main fuller |
| Medium | Can just be pushed off the front of the partner by hand | Straight | Ease the jib halyard a little |
| Heavy | Hard against the back of the partner | A little prebend | Move the shroud pins down on the adjusters; main flatter |
Trim by condition
- Rig tension
- Enough to stop excess jib luff sag.
- Changing pins
- Ease the jib halyard before pulling down on the main halyard to move the pins.
- Outhaul
- Never ease it more than a sideways fist.
- Racing kit
- Fine-tune shroud adjusters and the pro-kit outhaul and vang.
- Written by Bob Adam of Zim Sailing, the US builder/distributor.
- The post spells the gauge 'loose gauge'; read as a Loos gauge, model not given.
RS Sailing — RS Feva Rigging Manual (Mk2) Mk2 manual V1, 2023
- Written for
- RS Feva class sails
- Tension gauge
- Not used
- How it’s measured
- Shroud setting by adjuster-plate hole.
- Source
- RS Sailing, Mk2 manual V1, 2023
Base setup
- Shroud adjuster
- Start with the pin in the third hole down on the shroud adjuster plate
- Jib halyard
- Only enough tension to stop the jib luff sagging while sailing
- Jib sheet
- Through the middle of the three holes on the clew plate
Trim by condition
- Shrouds
- The mast is supported at deck level by the gate and foredeck; the shrouds stop it bending when the jib halyard is tensioned, so the hole position changes how much it bends.
- Kicker
- Firmly tensioned for upwind work.
- The same starting hole is given in the earlier V5 manual (https://www.rssailing.com/wp-content/uploads/guides/RSFevaRiggingGuide.pdf). Older manuals had a 'Basic RS Feva Tuning Guide' appendix that is only available on third-party manual sites, which blocked access.
Settings are summarised from each sailmaker’s published guide (checked 2026-11-02). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.
Technical
RS Feva resource centre
How we verify parts
- Fit verified
- Each part listed here was matched to the RS Feva by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
- Class rules
- Fitting a part is not the same as it being legal for racing. Read the current RS Feva class rules before changing equipment, and ask your class measurer if a part is not original equipment.
- Class rulesInternational RS Feva Class Rules 2025 (change doc effective 2025-04-01); exact version not confirmed
- Class associationrsfeva.org
- Builder specificationsRS Feva on rssailing.com
- Racing guideThe right gear for the right application
- Racing guideWhat to do when rounding the mark
- Racing guideHow to conquer the layline
- Rigging helpRequest a RS Feva part