One-design race shop · Dinghy

MC Scow Race Shop

Everything you need to prepare, compete, and win.

Shopping for

MC Scow

  • 17 verified parts
  • 3 brands
  • Fit checked Nov 2026

Fit verified for MC Scow

All MC Scow equipment

17 parts

Can’t find a part for your MC Scow? Request a MC Scow part

Official Harken dealer

MC Scow deck layout

LOA
16 ft ( 4.8 m)
Beam
5 ft 8 in (1.7 m)
Main
135 sq ft (12.5 sq m)
Weight
420 lb (190.4 kg)

Ratchamatic® Mainsheet

Ratchamatic® Mainsheet — Harken layout for the MC Scow
Drawing: Harken
  1. 1 57mm Ratchamatic® Block — SwivelHarken 2625 $121.95
  2. 2 57mm Block — SwivelHarken 2600 $55.95
  3. 3 57mm Block — Swivel BecketHarken 2601 $62.95
  4. 7 29mm BlockHarken 348 $17.95
  5. 8 29mm BlockHarken 348 $17.95
  6. 10 29mm BlockHarken 348 $17.95

Cascading Vang System

Cascading Vang System — Harken layout for the MC Scow
Drawing: Harken
  1. 1 Micro Carbo-Cam CleatHarken 471 $31.95
  2. 3 29mm BlockHarken 348 $17.95
  3. 4 29mm Double Block — SwivelHarken 342 $53.95
  4. 6 Micro Carbo-Cam CleatHarken 471 $31.95

Systems and part numbers as published by Harken (checked 2026-11-04). Specifications are Harken’s; class rules decide what is legal for racing.

Go fast

MC Scow tuning guide

The MC is a cat-rigged scow tuned mostly with one rake number (about 28' 3", tape from the masthead to the centre of the transom), modest sidestay tension and then outhaul, cunningham, vang, traveller and board height by wind. North now sets sidestays on a Loos gauge (15 minus two turns) while Quantum and North's older edition just finger-tighten them, and UK's Porter uses a deflection test; rake also differs slightly by sail model.

North Sails — MC Scow Tuning Guide Current web page, undated

Written for
ZMAX, Magnum, ZAP and Rocket mainsails (one shared matrix)
Tension gauge
Loos; the equipment list says P-1 but the sidestay instructions say P-2 ("15 units")
How it’s measured
Rake: 50 ft tape on the wire main-halyard shackle, hoisted and latched, measured down to the centre of the deck at the stern where hull and deck meet. Forestay: measured up from the deck to a mark on the stay. Settings are keyed to how hard you are hiking, not to a wind number.
Source
North Sails, Current web page, undated

Base setup

Mast rake (AP)
28' 3" (stated for the Z Max, Magnum and Rocket)
Forestay mark
Adjust the Sta-Master so the mark is 742 mm (29 7/32") above the deck
Sidestays
Forward chainplate hole; tighten each side evenly to 15 on the gauge, then take two full turns off each side (base)
Board angle
Full down for light air is 103°, head flush with the deck
Spreader sweep
Standard spreaders 4"; maximum-length (18") spreaders 4.5" (shock cord tied between the side stays, measured to the back of the mast)
Heel
Aim for at most about 15°; never let water run over the leeward rail

Tuning matrix (Loos 15 minus 2 turns = base)

SettingSitting to leewardFull time on deck, not hikingJust starting to hikeMax hike, overpowered
Mast rake28' 3"28' 3"28' 3"28' 3"
Upper shroud tensionBase less ½ turnBaseBase plus ½ to 1 full turnBase plus 1 to 2 full turns
OuthaulRemove wrinkles, slight shelf on the footNo wrinkles, more shelfTo the black band, defined shelfMax
CunninghamNoneNoneFull tensionNone (as printed)
Outhaul / cunningham downwindCunningham off, outhaul easedCunningham off, outhaul easedCunningham off, outhaul easedCunningham off, outhaul eased
Vang upwindNoneTension in puffs75% vangFull, pull hard
Vang downwindNoneJust enough to straighten the leechPlay it with the waves: ease by the lee, on when higherPlay it with the waves: ease by the lee, on when higher
TravellerCentredCentred0–6" below centre6–9" below centre
Board heightAll the way down (103°, flush)All the way down (103°, flush)1" above deck2" above deck
Board downwind¼ down¼ down¼ down¼ down

Trim by condition

Full power (0–8 mph)
Helmsman sits forward by the mainsheet cleat. In puffs ease, bear off for speed, then trim and point. Mainsheet never cleated; in very light air start with the end of the boom over the leeward aft corner. Downwind: leeward board up about 75%, heel to leeward until the boom end kisses the water.
Ultimate speed (8–15 mph)
Boards flush or 1" up; outhaul to the black band; vang on as soon as you're overpowered (about 10 mph for a 150 lb sailor, 15 mph for 200 lb), then ease the sheet up to about a foot in puffs; more cunningham to flatten the sail and bend the mast, with the vang very hard once it is very windy; traveller down as much as 6". Downwind: heel to windward, windward board ¼ down, main fully out, work the vang in puffs.
Control & de-power (15–25 mph)
Board head about 2" above the box; ease the main up to 2 ft with lots of vang on; outhaul to the black band; cunningham as hard as possible; traveller up to 9" down (no more than 6" with crew). Ease the vang at least an arm's length before the windward mark. Downwind: reverse heel with one board ¼ down, never both boards down; ease the vang a little before gybing; head up 10–15° to get round big wave sets.
  • The guide names two gauges (P-1 in the equipment list, P-2 in the sidestay step); the 15 reading is only meaningful on the gauge you calibrate with.
  • The matrix shows cunningham "None" in the max-hike column, contradicting the text, which says to pull it as hard as possible in big breeze.

Quantum Sails (Melges) — Melges MC Scow Tuning Guide © 2026

Written for
Quantum Powerzone and Speed mainsails
Tension gauge
None: sidestays finger-tight
How it’s measured
Rake: 50 ft steel tape on the wire main-halyard shackle, latched at the top, measured to the centre of the deck at the stern where hull and deck meet.
Source
Quantum Sails (Melges), © 2026

Base setup

Mast rake
28' 3"
Sidestays
Forward chainplate hole; taut, tightened with fingers not a wrench (hand tension falls within about a 3" range)
Forestay
Aft cutout on the bow plate

Settings by wind (mph)

SettingPower up 0–8Ultimate speed 8–15Performance & control 15–25
BoardsLeeward board fully down, head flush with deckFlush or 1" upHead 2" above the board box
OuthaulTo the inboard edge of the white band (small shelf)To the inboard edge of the black bandTo the black band, don't ease
VangNone, uncleatedOn as soon as overpowered; more as it buildsHard; ease a little for the start and at least an arm's length before the windward mark
CunninghamOff, horizontal wrinklesMore to flatten and pointAs hard as possible
TravellerCentreline; when overpowered drop 6–8" or keep centred and vang-sheetDown up to 6"Up to 9"; no more than 6" with crew; up to 12" sailing alone
MainsheetNever cleated; very light air: boom end over the leeward aft cornerEase up to 1 ft in puffs to hold heelEase up to 2 ft with lots of vang
DownwindLeeward board ¾ up, heel to leeward, outhaul eased so the shelf is gone, vang and cunningham offHeel to windward, windward board ¼ down, leeward up; main fully out; vang played in puffsReverse heel, one board ¼ down (never both); ease vang slightly before gybing; head up 10–15° for wave sets

Trim by condition

Helm position
Sit forward by the mainsheet cleat upwind and downwind.
Heel
Never let water run over the leeward rail; keep heel constant.
Light-air technique
In a puff ease, bear off and build speed before trimming and pointing.
Powerboat waves
Trim and build speed; in big wakes add some vang downwind, then uncleat it.
  • Quantum's traveller limit when sailing alone (12") is written as "3" further" than 9" in North's text; the two guides share much of their wording.
  • Section headings are in mph, but some examples in the text use knots (overpowered at 10 or 15 knots; cunningham wrinkles "in this 0-8 knots").
  • An earlier Quantum edition with the same settings is hosted by US Sailing: https://www.ussailing.org/wp-content/uploads/2021/02/Quantum-Sails-MC-Scow-Tuning-Guide.pdf

UK Sailmakers (John Porter) — MC Scow Tuning Guide and Speed Tips – UK PS1 Sail Published 28 Aug 2017 on sailzing.com

Written for
UK PS1 mainsail
Tension gauge
None: shroud deflection by hand and turnbuckle faces
How it’s measured
Base shroud tension: lightly deflect the shroud and look for a 3–4" circle. Spreader sweep: line pulled tight between the tips, measured to the mast.
Source
UK Sailmakers (John Porter), Published 28 Aug 2017 on sailzing.com

Base setup

Mast rake
28' 3½" all-round
Shroud base
3–4" circle when lightly deflected
Spreaders
About 3½" sweep (stock is about 4"); sweep back about 1" more for drifters
Boards
Let down a couple of inches more than stock, leaving about ¾" between the board's leading edge and the front of the trunk (don't go further or you can damage the trunk)
Vang
Retie the boom-to-purchase line 2" shorter for more vang range

Trim by condition

Shrouds by wind
Medium: tighten 4 turnbuckle faces each side. Very windy: luff, tighten the leeward shroud, tack and do the other side, as tight as possible by hand.
Depowering order
Take the slack out of the vang, cunningham to medium, more vang as the puff builds then cunningham to max, outhaul hard, vang to max, then drop the traveller (the PS1 tolerates almost a foot of traveller down). Depower a few seconds before the puff.
Outhaul
Upwind, keep the slightest horizontal wrinkle in the foot until you need it to depower; ease it before the windward mark.
Point mode
A little cunningham and hard trim lets you hold almost 5° higher for up to 20 s in steady wind.
Too much vang
Easy to over-pull with the PS1: if the boat stops, ease a little.
  • Tips article by a UK Sailmakers representative on a third-party site; UK's own MC page publishes no tuning table.

North Sails — MC Scow Tuning Guide Rev R04 (2021 print)

Written for
Z-Max, ZAP and Z-1 Radial mainsails
Tension gauge
None: sidestays finger-tight (a wrench makes the rig too tight)
How it’s measured
Same tape method as the current guide.
Source
North Sails, Rev R04 (2021 print)

Base setup

Mast rake
28' 3" for Z-Max and ZAP; 28' 3.5" base for the Z-1 Radial
Sidestays
Forward chainplate hole; taut, finger-tight only
Heel
Aim for a maximum of about 12° and never wet the leeward rail

Trim by condition

Full power (0–8 mph)
Board flush with the deck; outhaul to the inboard edge of the white band (Z-1 Radial: ease ½" for power); no vang; cunningham off; traveller centred. Downwind: leeward board 75% up, heel to leeward.
Ultimate speed (8–15 mph)
Boards flush or 1" up; outhaul to the inboard edge of the black band; vang once overpowered; cunningham on; traveller down up to 6"; ease the sheet about a foot in puffs.
Control & de-power (15–25 mph)
Board head 2" above the box (on newer boats the line moves 2" forward); ease up to 2 ft; vang hard (ease an arm's length before the windward mark); cunningham max; traveller up to 9", no more than 6" with crew, 3" more sailing alone. Downwind: reverse heel, board ¼ down, never both boards.
  • Earlier North edition before the Loos-gauge sidestay base and the four-column matrix were added.

Settings are summarised from each sailmaker’s published guide (checked 2026-11-02). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.

Technical

MC Scow resource centre

How we verify parts

Fit verified
Each part listed here was matched to the MC Scow by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
Class rules
Fitting a part is not the same as it being legal for racing. Read the current MC Scow class rules before changing equipment, and ask your class measurer if a part is not original equipment.