One-design race shop · Dinghy

El Toro Race Shop

Everything you need to prepare, compete, and win.

Shopping for

El Toro

  • 33 verified parts
  • 6 brands
  • Fit checked Nov 2026

Fit verified for El Toro

All El Toro equipment

33 parts

Can’t find a part for your El Toro? Request a El Toro part

Go fast

El Toro tuning guide

The El Toro is an unstayed cat-rigged pram, so tuning means a stiff mast, the right rake for your mast-to-daggerboard distance, and downhaul, vang, traveller, outhaul and centreboard settings. The only published guide found is Hank Jotz's tuning tips on the class site (he refers to them as being for his own sails); wind is given in mph.

Hank Jotz — El Toro Tuning Tips Undated (class website page)

Written for
The author's own El Toro sails ('my sails'); no brand or model named
Tension gauge
None (unstayed rig)
How it’s measured
Rake: tape on the halyard shackle to the top centre of the transom. Mast bend: support the mast at both bands, sail slot up, hang 50 lb midway and measure the gap to a string between the bands (or height above the ground before and after).
Source
Hank Jotz, Undated (class website page)

Base setup

Mast stiffness
Bends less than 1.25 in. in all directions under the 50 lb test
Average mast
12 ft 11 in. from halyard shackle to the top deck
Ideal rake
13 ft 7 in. from halyard shackle to the top centre of the transom, assuming a 13.5 in. high transom at its centre
Mast-to-board distance
The ideal rake assumes 30–32 in. from the aft face of the mast at the step to the front of the daggerboard; under 30 in. the mast must be more upright (e.g. 28 in. might need 13 ft 9 in.)
Outhaul
Set to the band and leave it there

Trim by condition

Downhaul
Some luff wrinkles in very light air; over 5 mph just enough to remove them; ease to show some wrinkles on reaches and runs.
Vang upwind
Tight enough that the boom end rises only an inch or two when the sheet is eased in a puff or wave.
Vang downwind
A slightly firmer leech than upwind, with very little twist at the top batten; too much makes a large vertical wrinkle from head to clew ahead of the battens.
Mainsheet and traveller
Top batten section twisted off slightly, the top batten roughly parallel to the centreline; boom end over the transom corner (a rope traveller pulled down almost to the tiller). Never cleat the mainsheet upwind.
Centreboard
At 15 mph and above raise it an inch or two upwind; skippers under 100 lb may need 2–4 in.
  • Wind speeds are in mph.

Settings are summarised from each sailmaker’s published guide (checked 2026-11-02). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.

Technical

El Toro resource centre

How we verify parts

Fit verified
Each part listed here was matched to the El Toro by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
Class rules
Fitting a part is not the same as it being legal for racing. Read the current El Toro class rules before changing equipment, and ask your class measurer if a part is not original equipment.