One-design race shop · Multihull
Hobie Bravo Race Shop
Everything you need to prepare, compete, and win.
Fit verified for Hobie Bravo
All Hobie Bravo equipment
6 parts
Fit verified for Hobie Bravo
Rooster
Rooster Tell Tales - Teflon Coated (3 Green & 3 Red)
Part # ROO127491
$8.96
$9.95Fit verified for Hobie Bravo
Tylaska
Tylaska Spares – Fastales Wool Tell Tales
Part # TYL-TYBK-FT1
$15.99
Fit verified for Hobie Bravo
Ronstan
Ronstan Tell Tales - Tell Tails Kit (3 Pairs)
Part # RONRF4025
$9.91
$11.66Fit verified for Hobie Bravo
Ronstan
Ronstan Tell Tales - Leech Tails Kit (3 Pairs)
Part # RONRF4026
$9.91
$11.66
No Hobie Bravo parts match these filters.
Can’t find a part for your Hobie Bravo? Request a Hobie Bravo part
Go fast
Hobie Bravo tuning guide
The Hobie Bravo has an unstayed mast on an A-frame with a roller-furling, sleeved sail, so there is no rig tension or rake to set. Its "tuning" is the downhaul, roller-reefing in a breeze, the optional boom (outhaul and vang) and rudder rake. Hobie's assembly manual is the only source with numbers; no class or sailmaker tuning guide exists.
Hobie Cat Company (builder) — Hobie Bravo Assembly Manual (setup, reefing and rudder tuning) Revised 12 Sep 2002 (#93450010)
- Written for
- Standard square-top Bravo sail with 3 battens and roller furler
- Tension gauge
- None
- How it’s measured
- Rudder rake: from a line through the rudder pivot pins to the leading edge of the blade, 12" down from the bottom of the casting.
- Source
- Hobie Cat Company (builder), Revised 12 Sep 2002 (#93450010)
Base setup
- Downhaul
- Enough to pull all the wrinkles out of the sail sleeve (check the sleeve isn't twisted first); re-tension if the sleeve starts to twist on the mast
- Battens
- Longest in the middle, shortest at the bottom; tension each until well seated with no pocket wrinkles
- Rudder rake
- Factory 1-1/8"; more forward rake lightens the helm, less adds pull; aim for a near-neutral feel
- Rudder breakaway
- 17–26 lb, tested with a line round the blade 7" above its tip
Trim by condition
- Reefing
- Roll the sail around the mast with the furling line and cleat it at the A-frame; reef more as the wind rises, and set the reef so the mast float faces forward for best performance.
- Optional boom
- Designed to sail boomless, but the boom adds performance in strong wind: the outhaul moves the clew out along the boom, and the vang is pulled down and cleated to hold the boom at the height you want.
- Hiking
- In stronger winds hike out with your feet under the straps to keep the boat flat.
- An owner's assembly manual rather than a racing tuning guide; it has no wind-range settings.
Settings are summarised from each sailmaker’s published guide (checked 2026-11-02). Use the guide written for your sails, check it against the full guide, and stay inside the class rules.
Technical
Hobie Bravo resource centre
How we verify parts
- Fit verified
- Each part listed here was matched to the Hobie Bravo by part number against the builder’s specification or a manufacturer’s class guide, then checked again by an independent reviewer.
- Class rules
- We have no current one-design class rules on file for the Hobie Bravo. Racing legality depends on your class or handicap rules; check them before changing equipment.